Online Questions - Valid Practice To your NSE7_SDW-7.0 Exam (Updated 70 Questions)
Practice To NSE7_SDW-7.0 - Remarkable Practice On your Fortinet NSE 7 - SD-WAN 7.0 Exam
Fortinet NSE7_SDW-7.0 (Fortinet NSE 7 - SD-WAN 7.0) exam is a certification exam that assesses the knowledge and skills of IT professionals in software-defined wide area networking (SD-WAN) technology. NSE7_SDW-7.0 exam is designed to validate the expertise of network security professionals in deploying, configuring, and managing SD-WAN solutions using Fortinet products.
NEW QUESTION # 26
Refer to the exhibit.
Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)
- A. The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.
- B. The number of simultaneous connections among all source IP addresses cannot exceed five connections.
- C. The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.
- D. The number of simultaneous connections allowed for each source IP address cannot exceed five connections.
Answer: C,D
NEW QUESTION # 27
Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?
- A. get router info routing-table all
- B. get ipsec tunnel list
- C. diagnose debug application ike
- D. diagnose vpn tunnel list
Answer: C
NEW QUESTION # 28
Refer to the exhibit.
Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2.
Which two configuration settings are required for Toronto and London spokes to establish an ADVPN shortcut? (Choose two.)
- A. On the hubs, net-device must be enabled on all IPsec VPNs.
- B. auto-discovery-forwarder must be enabled on all IPsec VPNs.
- C. On the hubs, auto-discovery-sender must be enabled on the IPsec VPNs to spokes.
- D. On the spokes, auto-discovery-receiver must be enabled on the IPsec VPN to the hub.
Answer: C,D
NEW QUESTION # 29
Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)
- A. The sdwan_service_id flag in the session information is 0.
- B. Traffic does not match any of the entries in the policy route table.
- C. Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
- D. All SD-WAN rules have the default setting enabled.
Answer: A,B
NEW QUESTION # 30 
Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups.
Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)
- A. London generates an IKE information message that contains the Toronto public IP address.
- B. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.
- C. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
- D. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
Answer: B,C
NEW QUESTION # 31
Refer to the exhibit.
The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?
- A. When T_N1PLS_0 has a latency of 80 ms.
- B. When T_INET_0_0 and T_MPLS_0 have the same latency.
- C. When T_MPLS_0 has a latency of 100 ms.
- D. When T_INET_0_0 has a latency of 250 ms.
Answer: A
NEW QUESTION # 32
Refer to the exhibit.
The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?
- A. When T_N1PLS_0 has a latency of 80 ms.
- B. When T_INET_0_0 and T_MPLS_0 have the same latency.
- C. When T_MPLS_0 has a latency of 100 ms.
- D. When T_INET_0_0 has a latency of 250 ms.
Answer: A
NEW QUESTION # 33
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. Firewall policy ID 1 has source NAT disabled.
- B. Changes have been made on firewall policy ID 1 on FortiGate.
- C. FortiGate has terminated the session after a change on policy ID 1.
- D. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
Answer: B
NEW QUESTION # 34
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows a site-to-site topology between two FortiGate devices: branch1_fgt and dc1_fgt. Exhibit B shows the system global and system settings configuration on dc1_fgt.
When branch1_client establishes a connection to dc1_host, the administrator observes that, on dc1_fgt, the reply traffic is routed over T_INET_0_0, even though T_INET_1_0 is the preferred member in the matching SD-WAN rule.
Based on the information shown in the exhibits, what configuration change must be made on dc1_fgt so dc1_fgt routes the reply traffic over T_INET_1_0?
- A. Enable snat-route-change under config system global.
- B. Enable auxiliary-session under config system settings.
- C. Disable tcp-session-without-syn under config system settings.
- D. Disable allow-subnet-overlap under config system settings.
Answer: B
Explanation:
Controlling return path with auxiliary session When multiple incoming or outgoing interfaces are used in ECMP or for load balancing, changes to routing, incoming, or return traffic interfaces impacts how an existing sessions handles the traffic. Auxiliary sessions can be used to handle these changes to traffic patterns.https://docs.fortinet.com/document/fortigate/7.0.11/administration-guide/14295/controlling-return-path-with-auxiliary-session
NEW QUESTION # 35
Which three matching traffic criteria are available in SD-WAN rules? (Choose three.)
- A. Application signatures
- B. Internet service database (ISDB) address object
- C. URL categories
- D. Source and destination IP address
- E. Type of physical link connection
Answer: A,B,D
NEW QUESTION # 36
Refer to the exhibits.
Exhibit A shows the packet duplication rule configuration, the SD-WAN zone status output, and the sniffer output on FortiGate acting as the sender. Exhibit B shows the sniffer output on a FortiGate acting as the receiver.
The administrator configured packet duplication on both FortiGate devices. The sniffer output on the sender FortiGate shows that FortiGate forwards an ICMP echo request packet over three overlays, but it only receives one reply packet through T_INET_1_0.
Based on the output shown in the exhibits, which two reasons can cause the observed behavior? (Choose two.)
- A. On the sender FortiGate, duplication-max-num is set to 3.
- B. On the receiver FortiGate, packet-de-duplication is enabled.
- C. The ICMP echo request packets received over T_INET_0_0 and T_MPLS_0 were offloaded to NPU.
- D. The ICMP echo request packets sent over T_INET_0_0 and T_MPLS_0 were dropped along the way.
Answer: A,B
NEW QUESTION # 37
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?
- A. diagnose sys sdwan health-check
- B. diagnose sys sdwan log
- C. diagnose sys sdwan intf-sla-log
- D. diagnose sys sdwan sla-log
Answer: D
NEW QUESTION # 38
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?
- A. diagnose sys sdwan health-check
- B. diagnose sys sdwan log
- C. diagnose sys sdwan intf-sla-log
- D. diagnose sys sdwan sla-log
Answer: D
Explanation:
SD-WAN 7.2 Study Guide page 321 You can view the stored member metrics by running the diagnose sys sdwan sla-log command. Note that you must include the name of the performance SLA followed by the member configuration index number. To display the SLA logs per interface, you run the diagnose sys sdwan intf-sla-log command.
NEW QUESTION # 39
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set priority 10.
- B. Set cost 15.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set source 100.64.1.1.
Answer: A,B
NEW QUESTION # 40
Refer to the exhibits.
Exhibit B -
Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.
Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?
- A. port1 is referenced in a firewall policy.
- B. port1 is assigned a manual IP address.
- C. port1 and port2 are not administratively down.
- D. port2 is referenced in a static route.
Answer: A
NEW QUESTION # 41
Refer to the exhibit.
Which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules?
- A. All traffic from a source IP is sent to the same interface.
- B. All traffic from a source IP to a destination IP is sent to the same interface.
- C. All traffic from a source IP is sent to the most used interface.
- D. All traffic from a source IP to a destination IP is sent to the least used interface.
Answer: B
NEW QUESTION # 42
......
Fortinet NSE7_SDW-7.0 exam covers a wide range of topics, including SD-WAN deployment models, application identification, traffic management, security policies and troubleshooting. Candidates are required to demonstrate their knowledge of Fortinet's SD-WAN solution, as well as their ability to apply this knowledge to real-world scenarios. NSE7_SDW-7.0 exam consists of multiple-choice questions and practical exercises, which test the candidate's ability to configure and manage Fortinet's SD-WAN solution.
True NSE7_SDW-7.0 Exam Extraordinary Practice For the Exam: https://examsboost.dumpstorrent.com/NSE7_SDW-7.0-exam-prep.html